Sorteer op:
Sorteer op:
5 producten
5 producten


Ronde onderzetters - Dahlia (Mandala)
€38,95 EUR
Eenheidsprijs PerRonde onderzetters - Dahlia (Mandala)
€38,95 EUR
Eenheidsprijs Per

Ronde tray - Dahlia Mandala (L)
€54,95 EUR
Eenheidsprijs PerRonde tray - Dahlia Mandala (L)
€54,95 EUR
Eenheidsprijs Per
Medaillons - Mandala Dahlia
€25,95 EUR
Eenheidsprijs PerMedaillons - Mandala Dahlia
€25,95 EUR
Eenheidsprijs PerDeze medaillon mal kan samen met onze mal voor de acht (servet) ringen worden gebruikt, die speciaal ontworpen is om de basis te vormen voor deze medaillons. Samen vormen ze een unieke servetring.
(De mal voor de ringen is apart verkrijgbaar, de foto die zowel de medaillon mal als de ring mal laat zien is alleen ter illustratie. In dit artikel wordt alleen de medaillon mal geleverd.)

Set of 2 molds - Dahlia (Mandala) coasters with matching holder
Set of 2 molds - Dahlia (Mandala) coasters with matching holder
- a set of four coasters, engraved with the Mandala Dahlia. The coasters are 112 mm (4 2/5") wide and 8 mm (1/3") thick.
- a matching holder. The legs of the holder are 42 mm (1 2/3") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
The holder mold is part of our 'Mandala Dahlia' design line, in which besides these two mold are also a large tray and a set of 8 medallions.

Houder voor de 'Dahlia' onderzetters
€21,95 EUR
Eenheidsprijs PerHouder voor de 'Dahlia' onderzetters
€21,95 EUR
Eenheidsprijs PerSilicone mold for a holder for the Mandala Dahlia coasters.
The baseplate of the holder is engraved with the 'Mandala Dahlia' and especially designed for the coaster set with the same engraving, see the pictures (for illustrative purposes, this item is only for the holder mold).
The legs of the holder are 42 mm (1 2/3") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.
The holder mold is part of our 'Mandala Dahlia' design line, in which besides this mold are also a large tray, a set of four coasters and a set of 8 medallions, as shown in some of the pictures (for illustrative purposes, this item is only for the holder mold).
The holder mold and coaster mold are also as a set available, for a special setprice.
Show
per pagina