Holder for 10 cm (4") round Yin Yang (sunflower) coasters
SKU: MOSH0073
1795
€17,95 EUR
Prix unitaire parSilicone mold for a holder for four round coasters with a diameter of 10 cm (4"). The holder has a Yin Yang sunflower pattern engraved into it and is a perfect match for the coasters with the same pattern, for which we also have a mold available.
The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.
There is a separate mold with taller legs available, tall enough for eight coasters.
There is a separate mold with taller legs available, tall enough for eight coasters.
Partager
Holder for 10 cm (4") round Yin Yang (sunflower) coasters
SKU: MOSH0073
1795
€17,95 EUR
Prix unitaire parSilicone mold for a holder for four round coasters with a diameter of 10 cm (4"). The holder has a Yin Yang sunflower pattern engraved into it and is a perfect match for the coasters with the same pattern, for which we also have a mold available.
The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.
There is a separate mold with taller legs available, tall enough for eight coasters.
There is a separate mold with taller legs available, tall enough for eight coasters.
Partager
Get in touch
Contact
Borculoseweg 33
7244 NM Barchem
The Netherlands
+31 651125282
info@moldsandshapes.com
FOLLOW US ON: