Flower Theme - Lily

Silicone mold for a set of four coasters, engraved with the Lily Mandala. The coasters are 11.5 cm (4 1/2") wide and 8 mm (1/3") thick.

This holder mold is part of our Lily Mandala line, in which besides this mold are also molds available for a coaster holder, a set of 8 medallions and a tray of 25 cm (10"), as shown in one of the pictures (for illustrative purposes, this item is only for the coaster mold).

The coaster mold and holder mold are also as a set available, for a special setprice.

Silicone mold for a large tray with the Lily Mandala engraved into it. The tray is 25 cm (10") wide and 8 mm (1/3") thick.

The tray mold is part of our Lily Mandala line, in which besides this mold are also molds available for a set of 4 coasters, a coaster holder and a set of 8 medallions, as shown in one of the pictures (for illustrative purposes, this item is only for the tray mold).

Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.

Besides these two molds there are also Lily molds available for a set of 8 medallions and a tray of 25 cm (10"), as shown in one of the pictures (for illustrative purposes, this item is only for the coaster and holder mold).

Silicone mold for a set of eight decorative (napkin ring) medallions, engraved with the Lily Mandala. Each medallion is 5.5 cm (2 1/6") wide and 8 mm (about 1/3") thick.

This medallion mold can be used together with our mold for the (napkin) rings, which is especially designed to form the base for these medallions. Together they make a unique napkin ring. 

This holder mold is part of our Lily Mandala line, in which besides this mold are also molds available for a set of 4 coasters, a coaster holder  and a tray of 25 cm (10"), as shown in one of the pictures (for illustrative purposes, this item is only for the medallion mold).

Silicone mold for a holder for our Lily Mandala coasters. 

The legs of the holder are 42 mm (1 2/3") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).

Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.

This holder mold is part of our Lily Mandala line, in which besides this mold are also molds available for a set of 4 coasters, a set of 8 medallions and a tray of 25 cm (10"), as shown in one of the pictures (for illustrative purposes, this item is only for the coaster mold).

The holder mold and coaster mold are also as a set available, for a special setprice.