5 produits
5 produits
Trier par:
Round coasters - Dahlia (Mandala)
€38,95 EUR
Prix unitaire parRound coasters - Dahlia (Mandala)
€38,95 EUR
Prix unitaire parSilicone mold for a set of four coasters, engraved with the Dahlia Mandala. The coasters are 112 mm (4 2/5") wide and 8 mm (1/3") thick.
This mold is part of the theme 'Dahlia', which also includes the holder for these coasters, a tray and a set of 8 medallions, see some of the pictures (for illustrative purposes, this item is only for the coasters mold).
Round tray - Dahlia Mandala (L)
€54,95 EUR
Prix unitaire parRound tray - Dahlia Mandala (L)
€54,95 EUR
Prix unitaire parMedallions - Mandala Dahlia
€25,95 EUR
Prix unitaire parMedallions - Mandala Dahlia
€25,95 EUR
Prix unitaire parThis medallion mold can be used together with our mold for the (napkin) rings, which is especially designed to form the base for these medallions. Together they make a unique napkin ring.
Set of 2 molds - Dahlia (Mandala) coasters with matching holder
Set of 2 molds - Dahlia (Mandala) coasters with matching holder
- a set of four coasters, engraved with the Mandala Dahlia. The coasters are 112 mm (4 2/5") wide and 8 mm (1/3") thick.
- a matching holder. The legs of the holder are 42 mm (1 2/3") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
The holder mold is part of our 'Mandala Dahlia' design line, in which besides these two mold are also a large tray and a set of 8 medallions.
Holder for the 'Dahlia' coasters
€21,95 EUR
Prix unitaire parHolder for the 'Dahlia' coasters
€21,95 EUR
Prix unitaire parSilicone mold for a holder for the Mandala Dahlia coasters.
The baseplate of the holder is engraved with the 'Mandala Dahlia' and especially designed for the coaster set with the same engraving, see the pictures (for illustrative purposes, this item is only for the holder mold).
The legs of the holder are 42 mm (1 2/3") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.
The holder mold is part of our 'Mandala Dahlia' design line, in which besides this mold are also a large tray, a set of four coasters and a set of 8 medallions, as shown in some of the pictures (for illustrative purposes, this item is only for the holder mold).
The holder mold and coaster mold are also as a set available, for a special setprice.