Silicone mold for a holder for our Ocean themed coasters. The holder is large enough for four coasters of 10 x 10 cm (4" x 4") and 8 mm (1/4") thick.
You can fix the legs with a drop of glue or resin so that it becomes a solid piece (Tip: place the holder upside down, so that the supports will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the legs of the holder, because then they will no longer fit through the slots.
There is also amold for matching coasters available and a mold for a 25 cm (10") square tray with the same Ocean theme, see one of the pictures (for illustration purposes, this item is only for the coaster holder mold).
The 3 molds are also in two sets available (coasters with holder, coasters with holder and tray), for special setprices.
