Silicone mold for a coaster holder with ribbed edge. The holder can hold 4 coasters that are 10 cm (4") wide and 8 mm (1/3") thick and it is specifically designed for our round coasters with ribbed edges, but other round coasters of maximum 10 cm wide will fit too.

The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).

Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.

Besides the mold for the matching ribbed edge coasters, there are also ribbed edge molds available for trays in 3 different sizes, see one of the pictures (for illustrative purposes, this item is only for the coaster holder mold). Some of these molds are also in a set available, for a special setprice.

Ribbed edge coaster holder

Do you have a question?