Silicone mold for a holder for four round coasters with a diameter of 10 cm (4"). The holder has a Snowflake engraved into it and is is a perfect match for the coasters with the same pattern, for which we also have a mold available. BTW, the six-glass winebutler is based on this pattern too.

The legs of the holder are 40 mm (1 3/5") tall and you insert them from the bottomside through the slots of the base plate. You can fix the legs with a drop of glue or (UV) resin so that it becomes a solid piece (Tip: place the holder upside down, so that the legs will hang vertically while the glue or resin is drying).

Note: do not apply too thick a dome layer on the legs, because then they will no longer fit through the slots.

Holder for 10 cm (4") round Snowflake coasters

Do you have a question?