Set of 2 molds - Oval coasters with holder
Two silicone molds for:
- 4 Oval coasters. The coasters are 9.5 x 12.5 cm (3 3/4" x 5") wide and 8 mm (1/3") thick.
- a holder for these oval coasters. The holder is 12.5 x 16.5 cm (5" x 6 1/2") wide and 8 mm (1/3") thick. You can fix the supports of the holder with a drop of glue or resin so that it becomes a solid piece (Tip: place the holder upside down, so that the supports will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the supports, because then they will no longer fit through the slots.
The two molds are together with the mold for a large oval tray also as a set of 3 molds available, for a special setprice.
We also have molds available for the same size coasters and holder, but then engraved with thin 'Graceful lines'.
Share
Set of 2 molds - Oval coasters with holder
Two silicone molds for:
- 4 Oval coasters. The coasters are 9.5 x 12.5 cm (3 3/4" x 5") wide and 8 mm (1/3") thick.
- a holder for these oval coasters. The holder is 12.5 x 16.5 cm (5" x 6 1/2") wide and 8 mm (1/3") thick. You can fix the supports of the holder with a drop of glue or resin so that it becomes a solid piece (Tip: place the holder upside down, so that the supports will hang vertically while the glue or resin is drying).
Note: do not apply too thick a dome layer on the supports, because then they will no longer fit through the slots.
The two molds are together with the mold for a large oval tray also as a set of 3 molds available, for a special setprice.
We also have molds available for the same size coasters and holder, but then engraved with thin 'Graceful lines'.
Share
Get in touch
Contact
Borculoseweg 33
7244 NM Barchem
The Netherlands
+31 651125282
info@moldsandshapes.com
FOLLOW US ON: